Re: [Update REQ 5366]: geomview and OpenGL on DEC Alphas

[zeleznik at cs.utah.edu (Mike Zeleznik)]

  > If I remove these errors by fudging things, I see another error later on
  > at:
  > misc.c line 109
  >  HZ is undefined
  Hmmm... that should have been defined in <sys/param.h>.  You can
  fudge it by doing:
  #define	HZ	60

I did what you suggested, and got the system to build, but running it
resulted in an illegal instruction.  I thought maybe some object file from
your end slipped through, so did a "make clean", which blew up due to the
make stuff in src/lib/mg/ps.

When I run "make depend" in src/lib/mg/ps, here is what it does to the
src/lib/mg/ps/O.x11/Mkdep file:

----------------------------------------
# DO NOT DELETE THIS LINE -- mkdep uses it.
# DO NOT PUT ANYTHING AFTER THIS LINE, IT WILL GO AWAY.

 /usr/lib/cmplrs/cc/crt0.o handline.o hideline.o pstri.o mgpsdraw.o mgps.o \
   styline.o vect.o misc.o rand.o /usr/lib/cmplrs/cc//libexc_init.a

# IF YOU PUT ANYTHING HERE IT WILL GO AWAY
----------------------------------------

This causes make to complain:

  Make: Makefile: Must be a separator on line 7.  Stop.

Any help will be appreciated,
Mike
-------