Re: [Update REQ 5501]: geomview

[gbierner at cs.rice.edu]

> Yes, this is possible.  Start geomview with the command line
> "geomview -c -".  Geomview will then read from standard input and
> echo to standard output.


Thanks for the quick response!
Unfortunately, I have another quick question.  It's pretty clear cut how
to specify a geometry in gcl "(geometry geom-id geom-specs)."  I'm having
trouble finding the command that will tell geomview to display geom-id.  I
could always write it to a file and then load it, but I'd rather just do
it directly.

Thanks,
Gann

P.S.  I'm sure you guys have this, but I must just be missing it in the
manual.