[ REQ 6089]: "transparent" in geomview

[jeff at osiris.usi.utah.edu]

Hi,

I used to use the IRIS-GL version of geomview on my
SGI Power Indigo2 w/ extreme graphics.  When I upgraded
the OS to 6.2 I switched to the open-GL version.  I can't
seem to find anything that will allow me to display a
surface as "transparent" in the new version, whereas I
am sure I could do this in the old version.  Was this
functionality left out of the open-GL version?

Thanks in advance,

Jeffrey A. Weiss, Ph.D.
Orthopedic Biomechanics Institute, Bioengineering Dept, U. Utah
phone: 801-269-4035  fax: 801-269-4015  jeff at osiris.usi.utah.edu