[ REQ 6203]: Using Geomview with Maple V Release 4

[jims at clam.rutgers.edu]

My name is Jim Schmincke and I work at Rutgers University-Camden.
In the past, we've used Geomview 1.6.1 with older versions of Maple
via the gvplot library.  When we installed the new Maple software, I
regenerated the gvplot.m file according to the steps listed in
"gvplot.doc" and attempted to display 3d output.
  The result was an error message:

 
Error, (in gvplot) wrong number (or type) of parameters in function gc

And although Geomview was launched, no graphics were displayed.  I am
wondering if perhaps you know a way to fix this error?  Any help would
be greatly appreciated.

-Jim

--------------------------------------------------------------------------
Jim Schmincke,        | RUCS-Camden BSB Room 133 
jims at clam.rutgers.edu |                   http://clam.rutgers.edu/~jims/
--------------------------------------------------------------------------