[ REQ 5006]:

[daemon]

To whom it may concern:

  I work have been working with geomview for a couple weeks.  It seems
that I have run into a problem.  When translating mathematica graphics
who designs are points connected by lines, to geomview, it seems that
geomview neglects to copy the plotted points leaving only the lines.
To perhaps see what I am refering to, if you take a 3D rectangle that
has points plotted at each corner, and transfer that to geomview, you
will only see the lines that connected the points, and not the points
themselves.  Please respond if you have ever encountered such problems.

Eric Forrest
1-800-254-2223
email address
eforrest at bouchet.gprc.hamptonu.edu