[ REQ 5421]: Question about geomview

[guawu at enuxsa.eas.asu.edu]

Hi, there:
	Thanks for your last help and it has been very helpful to me.

	I can't find any GCL command equivalent to the 'reset' 
button on the control panel in the manual. Is there anyway so that 
I can send a command to have the same effect as that of pushing the 
'reset' button?

	Thank you very much. Your early response is greatly appreciated.
Have a nice holiday.

		Sincerely

		George Wu


	+----------------------------------------------------------+ 
	|		Guangxing George Wu			   |
        |	Department of Computer Science and Engineering	   |
	|	Office:		GWC 337    			   |
	|	Fax/modem/phone: ((555) 555-5555 (R)		   |
	|	Office phone:	 ((555) 555-5555 (O)		   |
	+----------------------------------------------------------+