[ REQ 5876]: Use of geomview for evolver application

[hyang at mcnc.org]

Hi, thanks for the help. I was able to install geomview successfully on
my HP workstation. 
How can I use it for the evolver display?
I've taken the following actions.

1. Modify the Makefile, and install.

# Remove #'s from following 3 lines for  HP workstation
# Omit -Aa if you're using gcc
CFLAGS= -Aa  -D_HPUX_SOURCE  -I/usr/include/X11R5 -DOOGL
GRAPH= xgraph.o
GRAPHLIB= -L/usr/lib/X11R5 -lX11

2. run evolver

$ evolver
Surface Evolver Version 2.00 April 30, 1996

Enter new datafile name (none to continue, q to quit): cube.fe
Enter command:

What command should I use now? According to the manual,I should type P option 8.
But I don't know what it meant.

Thanks.

Hong