[ REQ 5880]: Questions

[jhills at liberty.uc.wlu.edu]

	I wonder if you could help me with a few quick questions on your 
Geomview software. Is there any way to select more than one object at a 
time? Also, is there a way to merge an object into another object to 
that the final result is just one object? I have tried several times to 
use the (replace-geometry) command to do this, however I am confused 
about the syntax of the command, and what is meant by PART-SPECIFICATION. 


			Thank you,
					John Hills
					Washington and Lee University
					jhills at wlu.edu