[ REQ 6072]: Questions about Geomview's Mathematica interface

[ko at surya.ho.att.com]

Hello,

I have geomview 1.6.1, running on a Sparc (Solaris version).  I have some questions
about the Mathematica interface:

1) On p. 120 of the manual, it says

In[1] := ...
In[2] := ...
Out[2] := ...

This invokes geomview and loads the graphics object into it.

In[3] :=  ...
Out[3] := ...

This replaces the previous Geomview object by the new object.

If this means ``displays the new object'', then this does not happen for me.
The new object is not even added to the list of targets.

2) How can I have geomview display Mathematica plots with the same colors that
Mathematica uses?  Is there a default to set?

Thanks.


				Kostas Oikonomou