[ REQ 5745]: Help!!!!

[mcotter at modeler.uwsuper.edu]

Hello
I have a question I hope you can answer about Geomview.  I want to load approx.
90 geometry objects without them being displayed.  After loading is complete, I
want to display them using gcl.  All interactions are done using gcl and pipes.
ie, I want to make a movie which controls step size, speed, ect.  I've
experimented with several ideas, including the animator module and the
"animate" command, but when loading, the geometry objects are displayed.  This
is undesirable.  Other ideas I've used seems to fall short of expectation,
including delays between movie frames, ect. I've been working on this problem
for three weeks.  I hope you can help.  Thanks

Mark Cotter
mcotter at modeler.uwsuper.edu
((555) 555-5555


-- 
Mark Cotter