[ REQ 6032]: Question about Geomview

[mono at iet.unipi.it]

I am evaluating the capabilities of Geomview and I found it very interesting 
(I just picked up the manual for the moment). My question is the following:
is Geomview able to make mesh generation? Here at my university I am 
using  a FEM code for aerospace and mechanic applications for making the 
pre and post processing (I have my routines for applied electromagnetics). 
So essentially I need a code that gives me the files containing the nodes 
coordinates and the elements connettivity and a post processing wich 
visualize my data.  Thanks in advance for your precious help.
Regards
A.M.

------------------------------------------------------------------
Agostino MONORCHIO, PhD   (((       )))
Electromagnetics Group        _/_/
Dept. of Information Eng.   _/_/_/   
University of PISA         _/_/_/   email: mono at iet.unipi.it
via Diotisalvi 2          _/_/_/   voice: +39.50.568675 (568511) 
I-56126 PISA        _/_/_/   fax:+39.50.568522
   Italy                 _/_/_/   http://radar.iet.unipi.it/~mono       
=========================================